Našao sam još i ovo:
Seat heater module
The seat heater module and climate control module communicate via communication line terminal #A9 in the climate control module and terminal #A2 in the seat heater module (left-hand side) and terminal #A10 in the climate control module and terminal #A2 in the seat heater module (right-hand side).
This communication allows faults detected in the seat heater to be diagnosed and the selected heat level (high or low) to be controlled with different pulse trains from the climate control module.
Power supply, seat heater module terminal #A4: +Ubat (measured from power ground).
Ground terminal, seat heater module terminal #A1: 0V (measured from power ground).
Seat heater pad
Seat heater pad (backrest) terminals #C1 and #C2: 1.4Ω- 2.0Ω.
Seat heater pad (seat) terminals #B1 and #B4: 1.7Ω- 2.3Ω.
Thermistor at approximately 21°C terminals #B2 and #B3: 5.5 kΩ.
Note! The above values apply to both the left and right seats.
Kaže još VADIS da kad se petlja po klima modulu obavezno odpojiti "akamalator"
